References & further reading
- ASME B31.3 Process Piping — pressure design of components and branch reinforcement (per edition in force where you practice).
- GB/T 20801.1-2025 (Pressure piping code — Part 1: Industrial piping) for thin-wall cylinder screening alignment where applicable.
- Listing standards is for traceability only; it is not an endorsement and does not replace licensed engineering review.
Model assumptions
- Branch reinforcement follows a simplified ASME B31.3 section 304.3.3 inspired layout: required area uses (d₁/sin β)×tr when β is the angle between branch and run axes (default β = 90°); tr is from ASME B31.3 thin-wall straight pipe, not GB/T 20801.1 appendix B auto-fill. A₁ and A₂ limits use the same effective width. β is clamped to 15°–90°. Set-in branches and multi-opening interaction rules are not modeled.
- Allowable stress and joint efficiency are entered manually; temperature coefficient Y is interpolated from GB/T 20801.1 Table 27 at design temperature (ferritic class, same as the pipe wall calculator GB mode).
Shareable URL
Use “Copy shareable link” below the grid to encode SI inputs. All math stays in the browser.
Frequently asked questions
- Will branch reinforcement match my spreadsheet exactly?
- Not guaranteed—geometry limits and area partitions are simplified. Cross-check critical joints with detailed software or handbook procedures.
Extended copy on this page (headings, references, assumptions, FAQs) may be drafted or localized with AI assistance; engineering judgment and governing codes still apply. Numerical models run locally in your browser as implemented. For contract-critical work, cite primary standards and qualified review.